Filter
Top Products
24
TASCAM M-164/M-164FX/M-164UF
4 Select the input channel for the return signal.
Push the INT. EFFECT RTN switch in to send the
return signal to channels 15-16. Leave the switch out
(do not press it in) to send the return signal to chan-
nels 13-14.
CAUTION
Do not connect anything to the STEREO IN jack when
using channels 15-16 for the return signal. Doing so cuts
(mutes) the return signal.
When connecting an iPod or other device to the STEREO
IN jack on channels 15-16, set the INT. EFFECT RTN switch
to channels 13-14 (pressed in) to send the return signal
to these channels.
5 Turn the ST switch ON for the input channel receiv-
ing the return signal, and use its fader to adjust
return levels.
When using AUX 1 for stage or cue monitoring, if you
want to monitor the sound with the effect applied, turn
the TO AUX 1 switch ON for the input channel receiving
the return signal.
Using external effects
External effects can also be used with this mixer.
Channels 1–6, 7-8 and 9-10 can have an external effect
applied by sending their signals to the external effect
through the AUX 1or AUX 2 bus. The return signal can be
input into any other channels as desired.
In the following explanation, the signals are sent through
the AUX 2 bus to an external effect, and the return signals
are received by channels 13-14.
When sending signals to an external effect through •
AUX 1, turn the PRE switch OFF to send the post fader
signal.
When receiving external effect signals back through •
channels 13-14, do not set the internal effect return
to channels 13-14 (by setting the INT. EFFECT RTN
switch to CH 13-14).
If the AUX 2 bus is used to send signals to an external •
effect, the AUX 1 bus can still be used for monitoring.
With M-164 FX and M-164 UF units, by sending AUX 1 •
to an external effect and AUX 2 to the internal effect,
two types of effects can be used.
First, connect the input jack of the external effect to the
AUX SEND 2 jack first, and connect the external effect
output jacks to the L/R input jacks of mixer channels 13-14.
AUX 2
knob
AUX MASTER 2
knob
CH 13-14
L/R jcak
CH
1-6
7-8
9-10
AUX SEND 2 jack
Input
terminal
Output
terminal
External
effect
1 Use the AUX 2 knob of each channel to adjust the
level of the channel signal sent to the effect.
2 Use the AUX MASTER 2 knob to adjust the overall
level of the signal sent to the effect.
3 Set the effect as desired.
4 Turn the ST switch for channels 13-14 ON, and use
its fader to adjust the return level.
When using the AUX 1 bus for monitoring, turn the TO
AUX 1 switch for channels 13-14 ON to also monitor the
effect return signal.
4 − Using the mixer