Filter
Top Products
6 TASCAM VL-X5 Owner's Manual
Installation
Installation
1 Precautions
Handling
Do not grab the speaker driver unit : the VL-X5 is packaged in box fitted tight, so your attention is required when
taking speakers out of the box. To avoid the possible damage to the speaker units, hold both sides of the speaker to
pull it out of the box. The units should not be touched to avoid damage even after it is out of the box.
Recommend to use high quality balanced or unbalanced cable for input connection.
Turn off the power of the VL-X5 and turn the Volume control of the VL-X5 to minimum before kaming the
connection.
Connection
Connect XLR balanced or TRS balanced/unbalanced input of the VL-X5 to the output terminal of the audio
equipment.
2 Connection
Assure that the power switch of VL-X5 is turned off and volume control of VL-X5 is turned to minimum. Connect
male side of XLR balanced cable, TRS balanced cable, or TS unbalanced cable to the input connector of the VL-
X5.
3 Connecting to the audio equipment
Before connecting, make sure its power is turned off.
Plug the XLR balanced, TRS balanced or TS unbalanced cable to the corresponding output connectors of the audio
equipment.
Pre-Amplifier, Sound card, Mixer Output
VL-X5 VL-X5
XLR Balanced Cable
XLR / TRS Combo Jack
Power Cord
TRS Balanced or Unbalanced Cable
Power Cord
XLR
PIN 1: GND
PIN 2: HOT
PIN 3: COLD
TRS
Tip: HOT
Ring: COLD
Sleeve: GND