Filter
Top Products
NonLin2
/
11
EE NN GG LL II SS HH
TWIST TYPE
Type
Selects which type of funky effect treatment to be used on the reverb. Twist Type
should be regarded as a spice capable of sparking imagination in the mix process. Try
the effect on all sorts of different sources to add character or make them stand out. If
spectral shaping using the Twist parameters gets out of control, the Lo and Hi cuts
can be used to stay within limits.
Note: When the Twist Ratio is set at 0%, Twist Type has no effect.
Ratio
Range: 0 – 100%
Applies the selected amount of “Twist” to the reverb.
Note: When the Twist Ratio is set at 0%, Twist Type has no effect.
FILTER
Lo Cut
Range: 20Hz to 20kHz
Lo Cut on the Reverb Input.
Hi Cut
Range: 20Hz to 20kHz
Hi Cut on the Reverb Input.
Note: Setting the two filter cut off frequencies is not limited in range: It is possible to
set a higher low cut frequency than the high cut frequency. Due to the design of these
filters, the output of the reverb will in this case be phase-reversed. Setting Low Cut
and Hi Cut filters to exactly the same frequency will not give any reverb signal!
WIDTH
Range: 0 – 100%
Adjusts the Output Stereo Width. 0% denotes mono, while 100% is max width. In
case the plug-in is used in a mono-mono configuration, the Width does not have any
affect and is therefore disabled.
Note: The reverb style and diffuse parameters also affect the perceived width of the
effect. Width difference between styles is most obvious at low diffuse ratios.