Filter
Top Products
CROSS FADER SECTION
!9CROSS FADER
Mixes the signals assigned by the C.F. ASSIGN
SWITCH
!4 to either side of the crossfader. When the
crossfader is set in the center position, both the left and
right signals will be heard. This fader is user replaceable
and may be changed easily by following this user
guide's instructions carefully. See"HOW TO CHANGE
THE CROSSFADER".
*
Replace this fader with a Vestax CF-PCV
replacement inputfader.
@0C.F. CURVE SELECT SWITCH
Adjusts the crossfader curve. A clockwise rotation
gives a gentle crossfade, good for long running
mixes, whereas a counter clockwise rotation gives a
sleep crossfade which is good for scratching and
cutting.
MONITOR SECTION
@3MONITOR MODE SELECT SWITCH
When this switch is set to "SPLIT", the master signal
is always heard through the right ear-cup with the
"monitor" PGM being heard in the left ear-cup. The
monitor PGM sent the headphone is controlled
through the MONITOR MODE SELECT SWITCH.
When set to "STEREO" no master output is heard in
the headphones, and only the signal selected by
MONITOR SELECT SWITCH will be heard in both
ear-cups.
@4MONITOR MODE LED
This LED will be illuminated when the MONITOR
MODE SELECT SWITCH
@3 is on.
@5PHONES JACK
Use this jack to connect headphones. Headphones
with an impedance of 8ohm to 600ohm can be used
on this unit.
*For best sound quality Vestax recommends using
Headphones with 150ohm impedance.
@1MONITOR EQ (HI/LOW)
Adjusts the HI and LOW frequencies for Headphone
monitoring.
@2MONITOR LEVEL
Adjusts the headphone monitor level.