Filter
Top Products
10
To install the UHF-8800 to a 19” rack case, complete the steps below.
1. Align the UHF-8800 with the desired space in rack and slowly slide in, rear panel first.
2. While aligned, use rack case screws (not included) in the order shown below to stabilize the UHF-8800 in
its space, using the “X” rotation (numbered below) will ensure even tension and plush alignment.
Mounting
NOTE: Depending on your rack case design, it may be neces-
sary to allow for sufficient space for the antennas.
NOTE: Do not tighten screws firmly until all screws are in place.