Filter
Top Products
14
UHF-8800 & stage monitor/p.a. loudspeakers
If you will be using the UHF-8800 with stage monitors and/or P.A. system, try the following:
• Place the stage monitor directly behind the microphone.
• Locate the P.A. loudspeakers so that they point away from the rear of the microphone. (With the speakers
located in these positions, the possibility of feedback is greatly reduced).
• Always check the stage setup before a performance to ensure optimum placement of microphone and
monitors.
IMPORTANT: Every wireless microphone installation is a unique situation, and can present a variety of
problems. Never attempt a live performance without first conducting a “walkthrough” test of the system in
the performing area. If major changes (additional wireless systems or intercoms, relocation of scenery, etc.)
have been made since the last walk-through test, check the wireless system again, as close to performance
time as possible.
P.A. Speakers Facing Away
From Rear of Microphone
Monitor Directly Behind
Microphone
1. Press the POWER button on the UHF-8800 receiver’s front panel.
2. Adjust the receiver’s VOLUME controls to approximately 50%.
3. Switch the microphone’s POWER BUTTONS to the ON positions.
4. Talk or sing into the microphones. During normal operation, the RF/AF signal LED’s will light when a
microphone is being used.
5. Adjust the receiver’s VOLUME controls until the output levels are balanced with eachother and other
possible source output i.e. CD+G tracks.
Operations