Filter
Top Products
Pairing Buses or Aux Sends 105
01V96 Version 2—Owner’s Manual
Bus Outs
8
Pairing Buses or Aux Sends
You can pair adjacent odd-even (in this order) buses or Aux Sends for stereo operation.
Paired bus and Aux Send linked parameters and non-linked parameters (that are available
for independent controls) are listed below:
** You can set this parameter for each channel independent-
ly if the GANG button is turned off on the /INS/DLY |
DLY page.
***You can set this parameter for each channel independent-
ly on the EQ | ATT page, but the paired channel settings
are linked on the EQ | Edit and View pages.
Parameters marked with an asterisk * are available only for Bus Outs.
1 Press the DISPLAY ACCESS [PAIR/GROUP] button repeatedly until the
Pair/Grup | Output page appears.
The parameters on this page are described below.
A STEREO/MONOx2
These buttons turn Bus or Aux Send pairs on or off.
B F. S
This button determines whether Aux Sends follow the Input Channel Surround Pan
when the 01V96 is in any Surround mode other than “Stereo.” When this button is
turned on, Aux Sends follow the Input Channel Surround Pan. This is useful for feeding
Surround signals to external Surround effects processors.
2 Move the cursor to the MONOx2 button for the desired Bus or Aux Send,
then press [ENTER].
The buses or Aux Sends are paired.
3To cancel a pair, move the cursor to the STEREO button for the desired Bus
or Aux Send, then press [ENTER].
Linked parameters
[SEL] buttons
Fader
Channel on/off
Insert on/off
Solo on/off
Comp settings
Comp insert position
EQ settings
Fader group
Mute group
Fade time
Recall safe
Bus to Stereo on/off
*
Bus to Stereo fader
*
Non-linked parameters
Output Patching
Insert Patching
Delay on/off
Delay time
**
Bus to Stereo Pan
*
Attenuators
***
1
2