Filter
Top Products
New Functions in 01V96 Version 2 7
01V96 Version 2—Owner’s Manual
New Functions in 01V96 Version 2
The following functions have been added to the 01V96 as part of the upgrade of the firm-
ware from version 1.0 to version 2.0.
Aux Sends
•If an Aux Send is set to pre-fader, you can set the Pre point before or after channel mute.
→ page 114
Monitor
•You can select whether the Input Channel’s Pan setting is used when the Input Channel Solo
signal is set to Pre Fader. → page 132
•Raising the channel faders for soloed Channels from –∞ can unsolo the Channels.
→ page 132
Surround Pan
•The on/off status of the Follow Pan button is reflected in the pan and Surround Pan
settings. → page 135
Group/Link
•The Fader Group Master function enables you to control the overall level of the Fader group
channels simultaneously while maintaining the relative level balance of each channel.
→ page 152
•The Mute Group Master function enables you to mute all channels in a Mute group
simultaneously. → page 153
Internal Effects
•You can add optional Add-On Effects to the preset effects. → page 162
Scene Memory
•Any channel or parameter settings in the current scene can be copied and pasted into other
scenes. → page 173
•You can select additional parameters for the Recall Safe function. → page 172
Remote Control
•Cubase SX has been added as a target of the Remote layer. → page 189
•Yamaha’s proprietary Advanced DAW protocol has been added to Nuendo, Cubase SX, and
General DAW. This enables you to control these devices using the 01V96’s SELECTED
CHANNEL section. (Controllable functions vary depending on the DAW software and ver-
sion you are using.)
Other Functions
•You can set the Routing ST Pair Link so that the routing from paired channels to the Stereo
Bus is linked. → page 232
•You can assign the selected channels to a Fader or Mute group using the USER DEFINED
KEYS. → page 247
•You can switch the windows of the included Studio Manager software application using the
USER DEFINED KEYS. → page 247