Filter
Top Products
112 Chapter 9—Aux Outs
01V96 Version 2—Owner’s Manual
Viewing Aux Out Settings
You can view and adjust the parameter settings for the currently-selected Aux Out on the
View | Parameter and Fader pages.
■ Viewing the Compressor and EQ Settings
To display the View | Parameter page, use the corresponding [SEL] button to select the
desired Aux Out (1–8), then press the DISPLAY ACCESS [VIEW] button, then press the
[F1] button.
The parameters on this page (and the procedure for setting them) are the same as for Input
Channels, except that this page does not include the Gate and Phase parameters (see
page 87).
■ Viewing Faders and On/Off Parameters
To display the View | Fader page, use the corresponding [SEL] button to select the desired
Aux Out (1–8), then press the DISPLAY ACCESS [VIEW] button, then press the [F2] but-
ton.
• ON/OFF ........................ This button turns the currently-selected Aux Out (1–8) on or
off. It links with the corresponding [ON] (1–8) button in the
Master layer.
• Fader.............................. This fader sets the currently-selected Aux Out (1–8) level. It
links with the corresponding fader (1–8) in the Master layer.
The fader knob is highlighted when the fader is set to 0.0 dB.