Filter
Top Products
Viewing Aux Send Settings for Multiple Channels 117
01V96 Version 2—Owner’s Manual
Aux Outs
9
Viewing Aux Send Settings for Multiple Channels
You can view and set parameters for all Aux Send 1–8, including setting levels and Pre/Post
parameters.
This is convenient when you wish to visually check all Aux Send settings or simultaneously
adjust the levels of certain channels routed to Aux 1–8.
1 Press one of the FADER MODE [AUX 1]–[AUX 8] buttons repeatedly until the
page listed below that contains the desired channels appears.
-View1-16 page
This page displays the Aux Send levels of Input Channels 1–16.
-View17-STI page
This page displays the Aux Send levels of Input Channels 17–32 and ST IN Channels
1–4.
These pages display the source Input channels and the corresponding Aux Sends in a
matrix. The parameters on these two pages (and the procedure for setting them) are the
same.
A DISPLAY
Use the following buttons to display the desired parameters.
• LEVEL............................Select the LEVEL button to display Send level bar graphs for
Input Channels routed to Aux 1–8.
• PRE/POST.....................Select the PRE/POST button to display signal source points for
Input Channels routed to Aux 1–8.
B FIX/VARI
These buttons indicate the Aux mode (Fixed or Variable) for Aux Out 1–8 and are only
for display purposes.
C LEVEL
This field displays in dB the level of the Aux Send currently-selected by the cursor.
2 Move the cursor to either the DISPLAY LEVEL or PRE/POST button, then press
[ENTER] to display the Level or Pre/Post parameters.
1
3
2