Filter
Top Products
124 Chapter 10—Input & Output Patching
01V96 Version 2—Owner’s Manual
Changing the Signal Path to the ADAT OUT Connector, Slot,
or OMNI OUT connectors
Follow the steps below to change the signal path patched to the ADAT OUT connector, the
optional mini-YGDAI card installed in the slot, or the OMNI OUT connectors.
1 Press the DISPLAY ACCESS [PATCH] button repeatedly until the Patch | Out
Patch page appears.
Each parameter box displays the currently-patched signal path.
A SLOT 1-16
These parameter boxes set the routing of Slot Channel 1-16 signals.
B ADAT 1-8
These parameter boxes set the routing of ADAT OUT connector output channel 1-8 sig-
nals.
C OMNI 1-4
These parameter boxes set the routing of OMNI OUT connector 1-4 signals.
The parameter indicators are explained below:
2 Move the cursor to a patch parameter you wish to change, then rotate the
Parameter wheel or press the [INC]/[DEC] buttons to modify the patching.
3 Press [ENTER] to confirm the change.
Parameter value Description
–
No assignment
BUS1–BUS8
Bus Out 1–8 signal
AUX1–AUX8
Aux Out 1–8 signal
ST L/R
Stereo Out signal
INS CH1–INS CH32
Input Channel 1–32 Insert Out
INS BUS1–INS BUS8
Bus Out 1–8 Insert Out
INS AUX1–INS AUX8
Aux Out 1–8 Insert Out
INS ST-L/ST-R
Stereo Out Insert Out
CAS BUS1–BUS8
Bus 1–8 Cascade Outs
CAS AUX1–AUX8
Aux Bus 1–8 Cascade Outs
CAS ST-L/ST-R
Stereo Bus Cascade Outs
CASSOLOL/CASSOLOR
Solo Bus Cascade Outs
Tip: You can store the Output Patch settings to the Output Patch library. Refer to Chapter 16
for more information.
1
2
3