Filter
Top Products
132 Chapter 11—Monitoring
01V96 Version 2—Owner’s Manual
Monitor and Solo Setup
For monitoring and solo setup, press the DISPLAY ACCESS [DIO/SETUP] button repeat-
edly until the DIO/Setup | Monitor page appears.
This page contains the following parameters:
A SOLO
This parameter turns the Solo function on or off. By default, it is set to Enabled.
B MODE
This parameter determines how the Solo function works. There are two options. The
setting affects only Input Channels.
• RECORDING............... In Recording Solo mode, soloed Input Channel signals are fed
to the Solo bus and output via the Monitor outputs. Other
buses (Stereo bus and Bus 1–8) are unaffected by this mode.
• MIXDOWN.................. In Mixdown Solo mode, soloed Input Channel signals are fed
to the Stereo bus and output via the Monitor outputs. Unso-
loed Input Channels are not fed to the Stereo bus while the Solo
function is enabled.
C SEL MODE
This parameter determines how the Input Channels will be soloed when you press the
[SOLO] button of each Channel. There are two options.
• MIX SOLO.................... In Mix Solo mode, any number of channels can be soloed
simultaneously.
• LAST SOLO ..................In Last Solo mode, only one channel can be soloed at a time by
pressing the [SOLO] button. The Solo function that was previ-
ously enabled for channels is automatically cancelled.
D LISTEN
This parameter determines the source of the Input Channel Solo signal: Pre Fader or
Post Pan. When Pre Fader is selected, turning on the PAN button below the Pre Fader
option will solo the channel with the pan position specified by the Pan setting even if the
source precedes the fader. This parameter is effective only in Recording Solo mode.
Tip:
•Recording Solo mode is convenient when you wish to monitor certain Input Channels while
recording, since the Stereo bus and Bus 1–8 signals are unaffected.
•Mixdown Solo mode is useful when you wish to mute unsoloed Input Channels and feed
soloed Input Channel signals to the Stereo bus during mixdown.
7
8
9
6
1
5
3 42