Filter
Top Products
Setting Up and Selecting Surround Pan Modes 139
01V96 Version 2—Owner’s Manual
Surround Pan
12
6To change the Surround Channel to Bus Out assignment, move the cursor
to the SURR/BUS SETUP button, then press [ENTER].
The DIO/Setup | Surr Bus page appears.
A BUS1–BUS8
These parameters select channels to be assigned to the Bus Outs in 3-1, 5.1, and 6.1 Sur-
round modes.
B INIT
These buttons reset the channel assignment to the default setting.
C Surround LR to Stereo
When this check box is on, the left and right front signals of the surround channels are out-
put from the STEREO L & R connectors.
7To change the assignment, move the cursor to the desired Bus parameter,
rotate the Parameter wheel to select a channel, then press [ENTER].
The channels are swapped between the selected Bus and the Bus to which the channel
assigned to the selected Bus was assigned previously.
8 Depending on the selected Surround mode or applications, patch the Bus
Out signals to the outputs, ADAT OUT channels, or slot output channels.
Connect a playback device or MTR to the output connectors.
Tip:
•Pressing the DISPLAY ACCESS [SETUP] button repeatedly also displays the Surr Bus page.
•Available Bus Outs vary depending on the Surround mode. For example, in 3-1 Surround
mode, Bus Outs 1–4 are available. In 5.1 Surround mode, Bus Outs 1–6 are available, and
in 6.1 Surround mode, Bus Outs 1–7 are available.
2
1
3