Filter
Top Products
162 Chapter 14—Internal Effects
01V96 Version 2—Owner’s Manual
F TEMPO
This section enables you to set the tempo and interval of the selected effects, and displays
certain parameters only when certain effect types are selected. Use the parameter control
on the left side of this section to adjust the value between 25BPM and 300BPM. When
the MIDI CLK button is on, the 01V96 updates the TEMPO data (BPM) based on the
MIDI Clock information received at the MIDI IN port. You can also specify the tempo
by moving the cursor to the TAP TEMPO button and double-clicking the [ENTER]
button. The 01V96 calculates the tempo based on the time interval between your two
taps (clicks) on the [ENTER] button.
G Meters
These meters indicate the input or output levels of the currently-selected effects proces-
sor. Select the IN button or OUT button to display the input levels or output levels
respectively.
Move the cursor to a parameter you wish to change, and rotate the Parameter wheel or
press the [INC]/[DEC] buttons to adjust the setting. You can store the edited settings as
a new program in the Effects library (see page 179).
About Add-On Effects
Installing optional Add-On Effects packages enables you to expand your effects selection
beyond the internal effects. Add-On Effects will be stored in and recalled from preset #45
and the subsequent preset programs. You can also store edited effects in user program #54
and the subsequent user programs. For more information on Add-On Effects, refer to the
installation guide that is included in your Add-On Effects packages.
Tip: If the Freeze effect is selected, the TEMPO section displays the record and playback
buttons for using the effect, the recording data condition, and a progress bar that indicates
the current status.
Tip: You can also view the input and output levels of the effects processors on the Meter |
Effect 1–4 pages (see page 34).
Note: Yo u cannot change the effects type on this page. To change the effects type, recall a
program that uses the desired effects type from the Effects library.