Filter
Top Products
Remote Control 189
01V96 Version 2—Owner’s Manual
Remote Control
17
17 Remote Control
This chapter describes the Remote function, which enables you to control external equip-
ment directly from the 01V96 top panel.
About Remote Function
The 01V96’s Remote function enables you to control external DAW (Digital Audio Work-
station) equipment, MIDI devices, recorders, etc.
There are two types of Remote functions (Remote and Machine Control):
■ REMOTE (Remote Layer)
To use these types of Remote functions, you must connect the 01V96 to a target device via
USB or an optional MY8-mLAN card installed in the slot, and operate the faders and [ON]
buttons on the top panel to control the external device remotely.
You can specify a target device and parameter values on the DIO/Setup | Remote page. This
layer is enabled when you turn on the LAYER [REMOTE] button. During Remote opera-
tion, the controls on the top panel enable you to control the external device. (You cannot
adjust the 01V96’s parameters unless you select a different layer.)
You can assign functions of a target device to the controls on the top panel of the 01V96 by
using Remote layer. The following targets are available for remote control:
• ProTools ........................You can remotely control Digidesign Pro Tools.
• Nuendo ..........................You can remotely control Steinberg Nuendo.
• Cubase SX .....................You can remotely control Steinberg Cubase SX.
• General DAW................You can remotely control DAW software that supports the pro-
tocol used by Pro Tools.
• User Defined.................You can also assign MIDI messages to the faders or [ON] but-
tons to remotely control a connected MIDI device, such as a
synthesizer.
• User Assignable Layer.......You can combine the 01V96 channels to create a custom
layer. (See page 233 for more information on this function.)
■ Machine Control
By using MIDI Machine Control commands and the DIO/Setup | Machine page, you can
control an external recording machine that is connected to the 01V96 MIDI port, USB port,
or optional MY8-mLAN card installed in the slot.
Tip: To control external devices from the 01V96, you can also use the User Defined buttons.
Refer to “19 Other Functions” for more information.