Filter
Top Products
Pro Tools Remote Layer 197
01V96 Version 2—Owner’s Manual
Remote Control
17
■ DISPLAY ACCESS section
•[PAIR/GROUP] button
Press this button while a Channel Display mode or Meter Display mode page is selected to
display a Group ID to which each channel belongs.
• [EFFECT] button
Press this button to display or hide the Insert window in Pro Tools.
■ Display section
• [F1] button
Press this button to reset the Clipping and Peak Hold indicators on Meter Display mode
pages.
•Tab Scroll buttons ([ ]/[ ])
These buttons switch the INSERT ASSIGN/EDIT parameter settings on Insert Display
mode pages.
■ Data Entry section
• [ENTER] button
This button switches the on/off status of the buttons on the display.
• Left, Right, Up, Down ([ ]/[ ]/[ ]/[ ]) cursor buttons
These buttons move the cursor on the display.
• [INC] & [DEC] buttons
The [INC] button works the same as the Enter key on your computer keyboard. The [DEC]
button works the same as the Esc key on your computer keyboard.
• Parameter wheel
The Parameter wheel enables you to adjust the currently-selected parameter, or execute the
shuttle and scrub operation. By default, it adjusts the value of the currently-selected param-
eter (The P.WHEEL MODE parameter indicates “Prm.”).
■ USER DEFINED KEYS section
• [1]–[8] buttons
You can assign one of 194 parameters to each of these buttons. In particular, if you assign
any of 54 Remote Control parameters to these buttons, you can operate the transport sec-
tion and select various Pro Tools modes from the 01V96 top panel. See page 235 for more
information on assigning the parameters to the buttons.
Parameter Function
DAW REC
Places Pro Tools in Record Enabled mode. The button indicator flashes while
the transport section is stopped. The indicator lights up when recording starts.
DAW PLAY
Starts playback from the current cursor position.
DAW STOP
Stops playback and recording.
DAW FF
Fast forwards the cursor position.
DAW REW
Fast rewinds the cursor position.
DAW SHUTTLE
Switches the Wheel mode to Shuttle.
DAW SCRUB
Switches the Wheel mode to Scrub (Jog).
DAW AUDITION
You can audition the pre-roll, post-roll, in-point area, or out-point area by
holding down the button to which this function is assigned and pressing a
button to which DAW PRE, DAW POST, DAW IN, or DAW OUT is assigned.