Filter
Top Products
210 Chapter 17—Remote Control
01V96 Version 2—Owner’s Manual
2 Press the DISPLAY ACCESS [DIO/SETUP] button repeatedly until the
DIO/Setup | Remote page appears, then set the TARGET parameter to USER
DEFINED.
You can now use the MIDI Remote function. Refer to the previous section for more infor-
mation on using the MIDI Remote function.
3 Move the cursor to the desired bank button (BANK parameter buttons 1–4),
then press [ENTER].
4 Press the [SEL] buttons for the desired channels.
Currently-assigned MIDI messages appear in the ON and FADER sections.
5 Move the cursor to the LEARN button in the ON section, then press [ENTER].
MIDI messages received at the MIDI IN port of the 01V96 will be assigned to the DATA
parameter boxes in the ON section.
6 Press and hold down the MIDI keyboard foot switch.
The MIDI Hold On message is assigned in the DATA parameter box.
MIDI messages are described below:
• 00–7F .............................MIDI messages are expressed in hexadecimal.
• END ...............................This message indicates the end of MIDI messages. Subsequent
messages assigned in the DATA parameter boxes will be
ignored.
• –...................................... This message indicates that no messages are assigned to the
DATA parameter boxes.
7 While continuing to hold down the foot switch, turn off the LEARN button.
8 Move the cursor to the third parameter box (“7F” in this example), then
rotate the Parameter wheel to change the value to SW.
“SW” is a variable that changes depending on the [ON] button’s on/off status. You can use
the following variables in MIDI messages.
• SW.................................. This variable is selectable only in the DATA parameter boxes of
the ON section. When the [ON] buttons are turned on, “7F”
(127 in decimal) is output. When the [ON] buttons are turned
off, “00” (0 in decimal) is output.
• FAD ................................This variable is selectable only in the DATA parameter boxes of
the FADER section. When you operate the faders, continuously
Tip: You can also choose the desired channels using the ID, SHORT, and LONG parameters.
Tip: When you click the LEARN button to assign MIDI messages, the 01V96 automatically
recognizes the end of the messages and assigns END and “–.”