Filter
Top Products
Machine Control Function 213
01V96 Version 2—Owner’s Manual
Remote Control
17
3 Move the cursor to the PORT parameter box in the MACHINE CONTROL sec-
tion (1), then rotate the Parameter wheel to select the MMC destination.
The following ports and slot are available as the MMC destination.
• MIDI ..............................MIDI port
• USB ................................USB port
• SLOT..............................Slot with an MY8-mLAN (mLAN card) installed
If USB is selected, move the cursor to the adjacent parameter box (on the right), and select
one of eight ports.
4 Move the cursor to the DEVICE ID parameter box, then rotate the Parameter
wheel to set the 01V96 MMC Device ID to the same ID number as the exter-
nal device.
MMC commands are effective on devices that use the same Device ID. Therefore, the
01V96’s MMC Device ID needs to match the ID of the devices you wish to control.
5To start remote control, press the DISPLAY ACCESS [DIO/SETUP] button
repeatedly until the DIO/Setup | Machine page appears.
This page contains the following parameters:
A LOCATE/TIME section
This section enables you to set the locate points.
• LOCATE 1–8 .................These buttons locate the positions (specified by the TIME val-
ues) on external machines.
• RTZ ................................This Return To Zero button locates the zero timecode position
on external machines.
• TIME..............................Locate points are specified in hour/minute/second/frame for-
mat.
• CAPTURE .....................These buttons capture the current position on external
machines and import the information into the TIME column.
B TRACK ARMING section
This section controls the tracks on external machines.
• 1–24 buttons.................These buttons turn external tracks 1–24 on or off, and set or
cancel their Record Ready mode.
• ALL CLEAR...................Turning on this button switches all buttons (1–24) simulta-
neously.
1
2
3
4