Filter
Top Products
Assigning Scenes to Program Changes for Remote Recall 219
01V96 Version 2—Owner’s Manual
MIDI
18
• Tx ON/OFF...................Transmission of Parameter Change messages is enabled or dis-
abled.
• Rx ON/OFF
................... Reception of Parameter Change messages is enabled or disabled.
• ECHO ON/OFF............This button determines whether Parameter Change messages
received at the MIDI IN port are echoed through to the MIDI
OUT port.
E BULK
This parameter row enables or disables reception of Bulk Dump data.
• Rx ON/OFF...................Reception of Bulk Dump data is enabled or disabled.
F OTHER COMMANDS
• ECHO ON/OFF............This button determines whether other MIDI messages received
at the MIDI IN port are echoed through to the MIDI OUT
port.
G Fader Resolution
This parameter specifies the resolution of the value output when you operate the
01V96’s faders. To transfer fader value data between two cascaded 01V96s, or to record
the 01V96 operation to or play it back from a sequencer, select the HIGH button. When
the LOW button is selected, the fader resolution switches to 256 steps.
Assigning Scenes to Program Changes for Remote Recall
You can assign 01V96 Scenes to MIDI Program Changes for remote recall. When you recall
a Scene on the 01V96, the unit transmits the assigned Program Change to the connected
MIDI device. When the 01V96 receives a Program Change, the assigned Scene is recalled.
Initially, Scenes 1 through 99 are assigned sequentially to Program Changes 1 through 99,
and Scene #0 is assigned to Program Change #100, although you can change these assign-
ments.
1 Press the DISPLAY ACCESS [DIO/SETUP] button repeatedly until the
DIO/Setup | MIDI/Host page appears, then specify ports for transmission
and reception of MIDI messages (see page 216).
2 Make connections using the ports selected in Step 1 so that the 01V96 can
transfer MIDI messages to and from the external device.
3 Press the DISPLAY ACCESS [MIDI] button, then press the [F2] button.
The MIDI | Pgm Asgn page appears.
Tip: You can store a Scene to Program Change assignment table to an external device by using
MIDI Bulk Dump or the included Studio Manager software.