Filter
Top Products
224 Chapter 18—MIDI
01V96 Version 2—Owner’s Manual
Parameters that feature a setting range of more than 128 steps (such as Fader and Delay
Time parameters) require two or more Control Change messages to specify the values.
For example, if you wish to control Fader parameters on certain channels using Control
Changes, you must assign the same channel to two Control Change numbers, and select
“FADER H” and “FADER L” for the Control Changes in the parameter boxes in the first
PARAMETER column.
If you wish to control Delay Time parameters on certain channels using Control Changes,
you must assign the same channel Delay parameter to three Control Change numbers, and
select “TIME LOW,” “TIME MID,” and “TIME HIGH” for the Control Changes in the
parameter boxes in the second (middle) PARAMETER column.
7 Press the DISPLAY ACCESS [MIDI] button, then press the [F1] button to dis-
play the MIDI | Setup page, then specify MIDI Transmit and Receive Chan-
nels.
8Turn on the CONTROL CHANGE Tx ON/OFF and Rx ON/OFF buttons.
01V96 parameters will now be set accordingly when the 01V96 receives corresponding
Control Changes. Also, when you adjust parameters on the 01V96, the 01V96 will transmit
corresponding Control Changes.
SURROUND
LFE H
INPUT1–32/ST IN1L–4R
LFE L
DIV (F)
DIV R
LR
FR
WIDTH
DEPTH
OFS LR
OFS FR
EFFECT
BYPASS
EFFECT1–4
MIX
PARAM1 H
PARAM1 L
:
PARAM32 H
PARAM32 L
Note: Parameters that feature a setting range in excess of 128 steps require an appropriate
combination of range parameters for successful MIDI Control Change.
Tip: You can initialize the Parameter to Control Change assignment table by moving the cur-
sor to the INITIALIZE button, then pressing [ENTER].
Note: Before controlling parameters using Control Changes, make sure that both Tx and Rx
ON/OFF buttons in the PARAMETER CHANGE row on the MIDI | Setup page are turned off.
HIGH MID LOW