Filter
Top Products
56 Chapter 5—Tutorial
01V96 Version 2—Owner’s Manual
EQ’ing the Input Signals
The 01V96’s Input Channels feature 4-band full parametric EQ. This section describes how
to apply EQ to the signals before they are recorded to the tracks.
1 Press the LAYER [1–16] button.
Input Channel Layer 1–16 is now available for control from the channel strip section.
2 Press the [SEL] button for the Input Channel to which you want to apply EQ.
3 Press the [EQ] button, then the [F1] button to display the EQ | EQ Edit page.
The EQ Edit page enables you to adjust the EQ parameters for the currently-selected chan-
nel.
4 Make sure that the EQ ON button (in the upper-left corner) is turned ON.
The EQ ON/OFF button turns the currently-selected Input Channel’s EQ on or off. If the
button is off, press the [ENTER] button to turn it on.
5 While a musician plays the musical instrument, adjust the EQ parameters.
To do so, move the cursor to the parameters in the lower half of the page, then rotate the
Parameter wheel to change the values. You can adjust the following parameters for the
LOW, L-MID, H-MID, and HIGH bands individually.