Filter
Top Products
82 Chapter 7—Input Channels
01V96 Version 2—Owner’s Manual
E Meters
These meters indicate the levels of the post-gate signals and the amount of gain reduc-
tion.
F ON/OFF
The ON/OFF button turns the currently-selected Input Channel’s gate on or off.
G PARAMETER
These controls enable you to set the gate parameters. (See page 272 for more informa-
tion on the parameters.)
Compressing Input Channels
To set the Input Channel compressors, use the [SEL] buttons to select the desired Input
Channel, then press the DISPLAY ACCESS [DYNAMICS] button, then press the [F3] but-
ton to display the Dynamics | Comp Edit page.
A POSITION
Use the Parameter wheel, or the [INC]/[DEC] buttons to select the position of the com-
pressor within the channel from the following options:
• PRE EQ.......................... Immediately before EQ (default)
• PRE FADER.................. Immediately before the fader
• POST FADER ...............Immediately after the fader
B STEREO LINK
This ON/OFF button enables you to pair compressors for stereo operation even when
channels are not paired.
C CURVE
This area displays the current compressor curve.
D TYPE
This field indicates the compressor type used by the currently-selected channel’s com-
pressor (COMP/EXPAND/COMP (H)/COMP (S)).
Tip:
• This function is unavailable for the ST IN Channels.
•You can store the gate settings in the Gate library, which features preset programs that can
be used for various applications (see page 183).
Note: Yo u cannot change the Compressor type on this page. To change the compressor type,
recall a program that uses the desired compressor type from the compressor library.
4
5
7
6
1
3
2