Filter
Top Products
22
MIDI Functions
▼
Left-hand section plays
a DOU-10 bass voice.
Right-hand section plays a
Clavinova piano voice.
SPLIT POINT
Z Press the [E.PIANO 1] voice selector while holding down the [MIDI/
TRANSPOSE] button. The E.PIANO 1 LED will flash.
X While still holding the [MIDI/TRANSPOSE] button, press the key on
the keyboard at which you want to set the split point. The E.PIANO 1
LED will light continuously. The split-point becomes the first key of
the left-hand section.
C Release the [MIDI/TRANSPOSE] button.
V To return to the normal full-keyboard mode, hold the [MIDI/TRANS-
POSE] button and press the [E.PIANO 1] voice selector, then release
both buttons.
NOTE
• When the power is turned ON the default split point key — F
#
2 — will be
automatically selected. If a new split point is selected it remains active
until the power is turned OFF or a different split point is selected.
● The MIDI Split & Right Local Off Mode
In the CLP-157 either the right- or left-hand section of the keyboard can be assigned to control an external
keyboard or tone generator. Assigning the left-hand section to external tone generator control was described in
the previous section. To assign the right-hand section to external tone generator control while playing the
Clavinova voices with the left hand, press the [E.PIANO 2] voice selector instead of the [E.PIANO 1] voice
selector when activating the Split mode (see the preceding section). All other operations are exactly the same as
described in the previous section.
● Transmitting the Panel Settings
This function causes all the current Clavinova control settings (selected voice, etc) to be transmitted via the
MIDI OUT terminal. This is particularly useful if you will be recording performances to a MIDI sequence re-
corder which will be used to control the Clavinova on playback. By transmitting the Clavinova panel settings
and recording them on the MIDI sequence recorder prior to the actual performance data, the Clavinova will be
automatically restored to the same settings when the performance is played back.
Z Hold down the [MIDI/TRANSPOSE] button.
X Press the [HARPSICHORD] voice selector.
C Release the [MIDI/TRANSPOSE] button.
MIDI/
TRANSPOSE
INOVA
O
NE
E. PIANO 1 E. PIANO 2
MIDI/
TRANSPOSE
A
NO 2
HARPSI-
CHORD
VIBES
NOTE
• See page viii for list of the panel settings transmitted by this function.
● Bulk Data Dump
This function is used to transmit all data stored in the Recorder memory
to a MIDI data storage device such as the Yamaha DOU-10 Disk Orchestra
Unit, other sequence recorders, or MIDI compatible computers.
Z Hold [MIDI/TRANSPOSE] and press the [PLAY] button. Transmis-
sion will begin.
XRelease the buttons.
NOTE
• Bulk dump will not function when the metronome is on or when the re-
corder is in operation.
MIDI/
TRANSPOSE
RECORDER
1
2
PLAY
REC