Filter
Top Products
40
CLP-880/860/840/820/820S
Factory Preset Recall
Options & Expander Modules
● Options
BC-8 Bench
A comfortable bench styled to match your Yamaha
Clavinova.
HPE-160 Stereo Headphones
High-performance lightweight dynamic headphones
with extra-soft ear pads.
KC-883 Key Cover
(for the CLP-820S only)
A convenient way to keep your keyboard clean and
dust-free.
All dual mode, split mode, reverb, effect, touch sensitivity, tuning
settings, and the settings affected by the Backup Functions can be
restored to their original factory preset values by holding the C7 key
(rightmost key on the keyboard) while turning the [POWER] switch
ON. This also erases all recorder data, and sets all Backup on/off
settings (F8: CLP-840/820/820S, F9: CLP-880/860) to “OFF”.
NOTE
• The factory setting list is found on page 42.
Troubleshooting
If you encounter what appears to be a malfunction, please check the following points before assuming
that your Clavinova is faulty.
1. No Sound When the Power is Turned ON
Is the AC plug properly connected to the Clavinova
and an AC wall outlet? Check the AC connection
carefully. Is the MASTER VOLUME control turned
up to a reasonable listening level?
Also make sure that a pair of headphones is not
plugged into the PHONES jack, and that the Local
Control (page 35) is ON.
2. The Damper Pedal Doesn’t Work
If the damper pedal doesn’t work, or notes are
sustained even when the pedal is not pressed, make
sure that the pedal cord is properly plugged into the
main unit (page 66: CLP-820S, page 60: CLP-860/
840/820, page 52: CLP-880).
3. The Clavinova Reproduces Radio or TV
Sound
This can occur if there is a high-power transmitter in
your vicinity. Contact your Yamaha dealer.
4. Intermittent Static Noise
This is usually due to turning ON or OFF a house-
hold appliance or other electronic equipment which
is fed by the same AC mains line as your Clavinova.
5. Interference Appears On Radio or TV Sets
Located Near the Clavinova
The Clavinova contains digital circuitry which can
generate radio-frequency noise. The solution is to
move the Clavinova further away from the affected
equipment, or vice versa.
6. Distorted Sound When the Clavinova is
Connected to An External Amplifier/Speaker
System
If the Clavinova is connected to a stereo system or
instrument amplifier and the sound is distorted,
reduce the volume of the external equipment to a
level at which the distortion ceases.
● If “Scn” appears on the display an internal malfunction has occurred. In this case, contact your
Yamaha dealer.
● Expander Modules
DOU-10 Disk Orchestra Unit
A range of MIDI recording and playback func-
tions, plus Yamaha DOC software, Disklavier
PianoSoft™, and General MIDI/Standard MIDI File
disk playback capability.
POWER