Filter
Top Products
30
CLP-880/860/840/820/820S
The Function Mode
F4.2: Split Balance.....................................................................................................................................
The volume levels of the two voices combined in the split mode can be adjusted as re-
quired by using this function. Use the [–/NO] and [+/YES] buttons to adjust the balance as
required. The balance range is from 0 through 20. A setting of “10” produces equal balance
between the two split-mode voices. Settings below “10” increase the volume of the Left Voice
in relation to the Right Voice, and settings above “10” increase the volume of the Right Voice
in relation to the Left Voice. Press the [–/NO] and [+/YES] buttons simultaneously to recall
the default setting (different for each voice combination).
F3.5: 1st Voice Effect Depth (CLP-880/860/840) ....................................................................
F3.6: 2nd Voice Effect Depth (CLP-880/860/840) ..................................................................
These functions make it possible to individually set the depth of the effect for the 1st and
2nd dual-mode Voices (“1st” and “2nd” is explained on page 16). Use the [–/NO] and [+/
YES] buttons to set the effect depth for the corresponding voice as required. The depth range
is from 0 through 20. A setting of “0” produces no effect, while a setting of “20” produces
maximum effect depth. Press the [–/NO] and [+/YES] buttons simultaneously to recall the
default setting (different for each voice combination).
NOTE
• The effect depth settings cannot be changed unless the EFFECT is ON. The Function mode must be
exited before EFFECT can be turned ON.
F3.5: Reset (CLP-820/820S) .......................................................................................................................
F3.7: Reset (CLP-880/860/840) .................................................................................................................
This function resets all dual-mode functions to their default values. Press the [+/YES]
button to reset the values. “End” will appear on the display when all functions have been
reset.
F4
CLP-880/860 Split Mode Functions
After selecting “F4.Y”, press the [+/YES] button to engage the split-mode function sub-
mode, then use the FUNCTION [<] and [>] buttons to select the desired split mode func-
tion, as listed below.
If the Split mode is not engaged “F4.-” will appear instead of “F4.Y” and the Split mode
functions cannot be selected. Also note that you must exit from the Function mode before the
Split mode can be engaged.
■ SHORTCUT: You can jump directly to the split-mode functions (F4) by pressing the
[FUNCTION] button while holding the [SPLIT] button.
NOTE
• Split mode function settings are set individually for each voice combination.
F4.1: Split Point ............................................................................................................................................
In addition to the split point setting method described on page 17, the split point can be set
via this function. Use the [–/NO] and [+/YES] buttons to set the split point as required, or
simply press the appropriate key on the keyboard: from “A-1” to “C7”. Press the [–/NO] and
[+/YES] buttons simultaneously to recall the default setting “F#2”.