Filter
Top Products
60
CLP-880/860/840/820/820S
6 7
240
127
110
220
Cord holder
● A voltage selector is provided in some areas.
N
Connect the pedal cord.
The pedal cord from the pedal box must be plugged into the
PEDAL connector on the rear of the main unit. Once con-
nected, attach the cord holders to the rear panel as shown, then
clip the cord into the holders.
M
Voltage Selector
Before connecting the AC power cord, check the setting of
the voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a
“minus” screwdriver to rotate the selector dial so that the cor-
rect voltage for your region appears next to the pointer on the
panel. The voltage selector is set at 240V when the unit is
initially shipped.
After the proper voltage has been selected connect the AC
power cord. A plug adaptor may be also provided in some
areas to match the pin configuration of the AC wall outlets in
your area.
● Use the vinyl tie that was removed from the bundled pedal cord in
step
C
to tie up any slack in the pedal cord.