Filter
Top Products
M7CL Owner’s Manual
Setup items required when you start up the M7CL for the first time
56
● Using the Centralogic section
(settings for eight channels)
Here’s how to use the Centralogic section and OVER-
VIEW screen to adjust the input level and pan/balance
sent to the STEREO bus for up to eight signals at a time.
1
Press a navigation key in the NAVIGATION
KEYS section so that the input channels
you want to control are assigned to the
Centralogic section.
The selected eight channels are shown in the OVER-
VIEW screen.
1 TO STEREO/MONO field
2
Make sure that in the TO STEREO/MONO
field of the screen, the ST symbol of each
channel is on (white characters on pink
background).
The ST/MONO symbol in the OVERVIEW screen
indicates the on/off status of the signal sent from that
input channel to the STEREO/MONO buses. If the ST
symbol is off (gray characters on a black background),
click the TO ST PAN/BALANCE field of the
SELECTED CHANNEL VIEW page to display a
popup window, then switch the symbol to on (→
p. 54).
3
In the Centralogic section, verify that the
[ON] of the corresponding input channel is
on.
4
In the STEREO/MONO MASTER section,
make sure that the [ON] key of the STEREO
channel is on, and raise the STEREO chan-
nel fader to 0 dB.
5
In the Centralogic section, raise the fader of
the corresponding input channel to an
appropriate volume.
In this state, you should now hear sound from the
speaker system that is patched to the STEREO chan-
nel.
If you don’t hear sound, check whether the LR meters
are moving in the METER field of the function access
area.
● If the LR meters are moving
It may be that the STEREO channel is not correctly
patched to the output jacks that are connected to
your speaker system. Check the output port patching
(→ p. 105).
● If the LR meters are not moving
Make sure that signals are being routed correctly to
the patched input channels.
6
To adjust the pan/balance of the signal sent
from each input channel to the STEREO
bus, press a knob in the TO STEREO/MONO
field of the screen to select it, and turn the
multifunction encoders of the Centralogic
section.
When you turn a multifunction encoder, the knob in
the TO STEREO/MONO field of the OVERVIEW
screen will also turn.
7
Use the navigation keys to switch the eight
channels controlled by the Centralogic sec-
tion, and make adjustments for other input
channels in the same way.
1
•You can also adjust the input level using the faders of the
INPUT section or ST IN section instead of the faders of the
Centralogic section.
HINT
• The signal being output from the STEREO channel can also
be monitored using headphones connected to the PHONES
OUT jack located below the front pad
p. 154.
HINT