Filter
Top Products
Sending the signal from an input channel to a MIX bus
M7CL Owner’s Manual
Input channel operations
5
71
4
Use the MIX bus selection buttons in the
function access area to select the send-
destination MIX bus.
5
Use the faders of the top panel INPUT sec-
tion or ST IN section to adjust the send
level from the input channels to the
selected MIX bus.
6
Repeat steps 4–5 to adjust the send level
for other MIX buses in the same way.
7
When you’re finished adjusting the MIX
send levels, press the “
×
” symbol in the
function access area.
The function access area display will return to its prior
state, and the M7CL will exit SENDS ON FADER
mode and return to normal mode.
• Alternatively, press a SEND LEVEL knob in the SELECTED
CHANNEL section to display a popup window, from which you
can select a MIX bus.
•You can also select a MIX bus by using the navigation keys
and the [SEL] keys in the Centralogic section. If the MIX
buses or MATRIX buses are selected when you press the
[SEL] keys, the setting of the MIX/MTRX ON FADER switch
button will be changed automatically.
• If you once again press the MIX bus selection button that is
currently selected, cue monitoring will be turned on for the
corresponding MIX channel. This method is convenient when
you want to monitor the signal that is being sent to the
selected MIX bus.
HINT
•You can assign the SENDS ON FADER function to a user-
defined key. This lets you quickly switch to SENDS ON
FADER mode for a specific MIX bus, and quickly switch back
again.
HINT