Filter
Top Products
M7CL Owner’s Manual
Sending the signal from an input channel to a MIX bus
70
D PRE button
This button switches the position at which the signal is
sent from the input channel to a VARI type MIX bus.
The signal is sent from the post-fader position when
this button is off, and from the pre-fader position when
this button is on.
E TO MIX SEND ON/OFF button
These are on/off switches for the signal sent from the
input channels to the MIX bus.
F TO MIX SEND LEVEL knob
This screen shows the send level of the signal sent
from the input channels to the MIX bus. To adjust the
level, operate multifunction encoders 1–8.
If the send-destination MIX bus is set to stereo, the TO
MIX PAN knob (for a ST IN channel, the TO MIX
BALANCE knob) and TO MIX SEND LEVEL knob
are shown in this location.
G ALL PRE button
This button selects PRE as the position from which
signals are sent from all input channels to VARI-type
MIX buses.
H ALL POST button
This button selects POST as the position from which
signals are sent from all input channels to VARI-type
MIX buses.
6
Use the TO MIX SEND ON/OFF buttons to
switch the signals sent from the input chan-
nels to the currently selected MIX bus on/
off.
7
If necessary, use the PRE buttons to select
the location of the signal that is sent from
each input channel to a VARI type MIX bus.
8
Repeat steps 3–6 to adjust the send level
for other MIX buses in the same way.
Here’s how you can use the faders of the top panel to
adjust the signal that is sent from all input channels to a
specific MIX bus.
1
Make sure that an output port is assigned
to each MIX bus to which you want to send
signals, and that your monitor system or
external effect etc. is connected to the cor-
responding output port.
For details on assigning an output port to a MIX bus
refer to p. 105. For details on connecting an external
device, refer to p. 46.
2
In the function access area, press the
SENDS ON FADER button.
The M7CL will switch to SENDS ON FADER mode.
The most recently selected group of MIX or MATRIX
buses will be assigned to the Centralogic section. The
faders of the INPUT section and ST IN section will
move to the send level values of each channel for the
currently selected MIX or MATRIX bus.
In SENDS ON FADER mode, the function access area
in the display will show the button that enable you to
switch between MIX ON FADER mode and MATRIX
ON FADER mode, and the buttons that enable you to
select the destination MIX/MATRIX buses.
1 MIX/MTRX ON FADER switch button
Pressing this button repeatedly will toggle between
MIX ON FADER mode and MATRIX ON FADER
mode.
B MIX/MATRIX bus selection buttons
These buttons enable you to select the destination
MIX/MATRIX buses. Only one button will appear if
two buses are paired as stereo.
3
Press the MIX/MTRX ON FADER switch but-
ton to select MIX ON FADER mode.
In this way, you can use the MIX/MATRIX bus selec-
tion buttons to specify the destination MIX buses.
• If the PRE button is on, you can also select PRE EQ (immedi-
ately before the attenuator) or PRE FADER (immediately
before the fader) for each MIX bus. This setting is made in the
BUS SETUP popup window (
→
p. 234).
• The PRE button is not shown for FIXED type MIX buses.
HINT
Using the faders (SENDS ON
FADER mode)
2
1