Filter
Top Products
M7CL Owner’s Manual
Warning/Error Messages
290
REMOTE: Data Framing Error! Invalid signals are being input to the REMOTE connector.
REMOTE: Data Overrun! Invalid signals are being input to the REMOTE connector.
REMOTE: Rx Buffer Full! Too much data is being received at the REMOTE connector.
REMOTE: Tx Buffer Full! Too much data is being sent from the REMOTE connector.
Saving Aborted. Saving to the USB storage device has been interrupted.
SLOT x: Data Framing Error! Invalid signals are being input from the SLOT x input port.
SLOT x: Data Overrun! Invalid signals are being input from the SLOT x input port.
SLOT x: Rx Buffer Full! Too much data is being received at the SLOT x input port.
SLOT x: Tx Buffer Full! Too much data is being sent from the SLOT x output port.
Storage Full! The file could not be saved because there is not enough space on the USB storage device.
Storage Not Found! The USB storage device could not be recognized.
Storage Not Ready! Access is not possible because the USB storage device is not ready.
Sync Error! [xxx] The M7CL is not synchronized with the [xxx] signal.
Tap Operation Ignored. Tap operation was ignored because the TAP TEMPO button is not displayed in the screen.
This Operation is Not Allowed. This operation has been ignored because the current user does not have permission.
Too Many Bands Used! Cannot Compare. More than 15 bands are used, when trying to copy 31BandGEQ and then compare with Flex15GEQ.
Too Many Bands Used! Cannot Paste to
Flex15GEQ.
More than 15 bands are used, when trying to copy 31BandGEQ and then paste to Flex15GEQ.
Total Slot Power Capability Exceeded! The I/O cards installed in the slots exceed the rated power capacity.
Unassigned Encoder.
Your operation has been ignored because there is no parameter that corresponds to the encoder you
operated.
Unsupported File Format! The file you attempted to load from the USB storage device is of an unsupported format.
USB: Data Framing Error! Invalid signals are being input from the USB connector input port.
USB: Data Overrun! Invalid signals are being input from the USB connector input port.
USB: Rx Buffer Full! Too much data is being received at the USB connector input port.
USB: Tx Buffer Full! Too much data is being transmitted from the USB connector input port.
Wrong Password! The password you input was incorrect.
Wrong Word Clock!
The M7CL cannot synchronize because the source selected by MASTER CLOCK SELECT in the WORD
CLOCK screen is not appropriate.
You Cannot Create User Key. The current user does not have permission to create a user key.
Message Meaning