Filter
Top Products
Sending the signal from an input channel to the STEREO/MONO buses
M7CL Owner’s Manual
Input channel operations
5
65
7
In the INPUT section or ST IN section of the
top panel, make sure that the [ON] key is
turned on for the input channel you want to
control, and raise the fader to an appropri-
ate position.
● Channels for which ST/MONO mode is
selected
8
In the TO STEREO/MONO popup window,
use the STEREO/MONO button to turn the
signal sent from the input channel to the
STEREO bus / MONO bus on or off.
For a channel that is set to ST/MONO mode, the sig-
nals sent to the STEREO bus and to the MONO bus
can be switched on/off individually.
9
In the TO STEREO/MONO popup window,
use the TO ST PAN knob to set the panning
of the signal sent from the input channel to
the STEREO bus.
● Channels for which LCR mode is
selected
8
In the TO STEREO/MONO popup window,
use the LCR button to turn the signals sent
from the input channel to the STEREO bus /
MONO bus on or off together.
For a channel that is set to LCR mode, the signals sent
to the STEREO bus and to the MONO bus are
switched on/off together.
9
In the TO STEREO/MONO popup window,
use the CSR knob to adjust the level differ-
ence between the signals sent from that
channel to the STEREO (L/R) bus and to the
MONO (C) bus.
10
In the TO STEREO/MONO popup window,
use the TO ST PAN knob to set the panning
of the signal sent from the input channel to
the STEREO bus and MONO (C) bus.
If the CSR knob is set to 0%, operating the TO ST
PAN knob of an INPUT channel will change the level
of the signals sent to the STEREO (L/R) bus and
MONO (C) bus as shown in the following diagram. In
this case, the TO ST PAN knob operates as a conven-
tional PAN knob, and no signal is sent to the MONO
(C) bus.
Operating the TO ST BALANCE knob of a ST IN
channel will change the level of the signals sent from
the ST IN L/R channels to the STEREO (L/R) bus and
MONO (C) bus as shown in the following diagram. In
this case, the TO ST PAN knob operates as a conven-
tional BALANCE knob, and no signal is sent to the
MONO (C) bus.
If the CSR knob is set to 100%, operating the INPUT
TO ST PAN knob will change the level of the signals
sent to the STEREO (L/R) bus and MONO (C) bus as
shown in the following diagram.
The subsequent steps will differ depending on whether
ST/MONO mode or LCR mode was selected for the
channel in step 5.
Signal level
CLR
Signal sent to the
STEREO (R) bus
Signal sent to the
STEREO (L) bus
TO ST PAN knob
CLR
Signal sent from
the ST IN (L)
channel to the
STEREO (L) bus
TO ST BALANCE knob
Signal level
CLR
Signal sent from
the ST IN (R)
channel to the
STEREO (R) bus
TO ST BALANCE knob
Signal level
CLR
Signal sent to the
STEREO (R) bus
Signal sent to the
STEREO (L) bus
PAN knob
Signal sent to the
MONO (C) bus
Signal level