Filter
Top Products
M7CL Owner’s Manual
Sending the signal from an input channel to the MATRIX buses
74
Here’s how you can use the multifunction encoders of the
Centralogic section to adjust the send level of the signals
sent from eight consecutive input channels to a specific
MATRIX bus.
1
Make sure that an output port is assigned
to each MATRIX bus to which you want to
send signals, and that your monitor system
or external effect etc. is connected to the
corresponding output port.
For details on assigning an output port to a MATRIX
bus refer to p. 105. For details on connecting an exter-
nal device, refer to p. 46.
2
Use the navigation keys to access the
OVERVIEW screen that includes the input
channel you want to control.
In the OVERVIEW screen, you can use the TO MIX/
TO MATRIX field to adjust the send levels to the
MIX/MATRIX bus.
1 TO MIX/TO MATRIX field
In this field you can switch the on/off status and adjust
the level of the signal sent from the input channel to
the MIX buses / MATRIX buses. Use the TO MIX/TO
MATRIX buttons of the SELECTED CHANNEL
VIEW screen to switch the type of send destination
shown in this field (→ p. 92).
B TO MATRIX SEND LEVEL knob
This screen shows the send level of the signal sent
from the input channels to the MATRIX bus.
To adjust the send level, press the appropriate knob to
select it, and operate multifunction encoders 1–8. If
the send-destination MATRIX bus is set to stereo, the
left one of the two adjacent knobs will be linked as the
TO MATRIX PAN knob.
3
Press the TO MATRIX SEND LEVEL knob for
the desired send-destination MATRIX bus.
A bold frame will appear around all TO MATRIX
SEND LEVEL knobs for that MATRIX bus.
4
Use multifunction encoders 1–8 to adjust
the send level of the signals sent from the
up to eight input channels to the selected
MATRIX bus.
If necessary, you can use the navigation keys to switch
the input channels that are assigned to the Centralogic
section, and adjust the send levels from other input
channels to the selected MATRIX bus.
5
If you want to make detailed settings for
MATRIX sends, press the TO MATRIX SEND
LEVEL knob inside the bold frame once
again.
When you press the currently selected TO MATRIX
SEND LEVEL knob once again, the MATRIX SEND
popup window will appear. The window includes the
following items.
1 SEND TO
This indicates the number, channel name, and icon of
the MATRIX bus that is currently selected as the send-
destination for signals.
B ←/→ buttons
Use these buttons to switch between send-destination
buses. You can switch consecutively through MIX
buses 1–16 and MATRIX buses 1–8.
C Channel select button
This indicates the channel number, the icon selected
for that channel, and the channel name. When you
press this button, that channel will be selected for
operations, and the corresponding [SEL] key will
light.
Using the Centralogic section
1
2
• If you want to monitor the signal being sent to a specific
MATRIX bus, use the navigation keys to access the corre-
sponding MATRIX channel in the Centralogic section, and
press the [CUE] key for that MATRIX channel.
HINT
1 7 8
2
3
4
5
6