Filter
Top Products
Sending the signal from an input channel to a MIX bus
M7CL Owner’s Manual
Input channel operations
5
69
Here’s how you can use the multifunction encoders of the
Centralogic section to adjust the send level of the signals
sent from eight consecutive input channels to a specific
MIX bus.
1
Make sure that an output port is assigned
to each MIX bus to which you want to send
signals, and that your monitor system or
external effect etc. is connected to the cor-
responding output port.
For details on assigning an output port to a MIX bus
refer to p. 105. For details on connecting an external
device, refer to p. 46.
2
Use the navigation keys to access the
OVERVIEW screen that includes the input
channel you want to control.
In the OVERVIEW screen, you can use the TO MIX/
TO MATRIX field to adjust the send levels to the
MIX/MATRIX bus.
1 TO MIX/TO MATRIX field
In this field you can switch the on/off status and adjust
the level of the signal sent from the input channel to
the MIX buses / MATRIX buses. Use the TO MIX/TO
MATRIX buttons of the SELECTED CHANNEL
VIEW screen to switch the type of send destination
shown in this field (→ p. 92).
B TO MIX SEND LEVEL knob
This screen shows the send level of the signals sent
from the input channels to the MIX bus. These knobs
are shown only when the send-destination MIX bus is
a VARI type.
To adjust the send level, press the appropriate knob to
select it, and operate multifunction encoders 1–8. If
the send-destination MIX bus is set to stereo, the left
knob of the two adjacent knobs will operate as a PAN
knob (for a ST IN channel, the BALANCE knob). If
the TO MIX SEND ON/OFF button is off, the knob
will be dimmed.
C TO MIX SEND ON/OFF button
These are on/off switches for the signal sent from the
input channels to the MIX bus. These buttons are
shown only when the send-destination MIX bus is a
FIXED type.
3
Press the TO MIX SEND LEVEL knob for the
desired send-destination MIX bus.
A bold frame will appear around all TO MIX SEND
LEVEL knobs for that MIX bus.
4
Use multifunction encoders 1–8 to adjust
the send level of the signals sent from the
up to eight input channels to the selected
MIX bus.
If necessary, you can use the navigation keys to switch
the input channels that are assigned to the Centralogic
section, and adjust the send levels from other input
channels to the selected MIX bus.
5
If you want to make detailed settings for
MIX sends, press the TO MIX SEND LEVEL
knob inside the bold frame once again.
When you press the currently selected TO MIX SEND
LEVEL knob once again, the MIX SEND popup win-
dow will appear. The window includes the following
items.
1 SEND TO
This indicates the number, channel name, and icon of
the MIX bus that is currently selected as the send-des-
tination for signals.
B ←/→ buttons
Use these buttons to switch between send-destination
buses. You can switch consecutively through MIX
buses 1–16 and MATRIX buses 1–8.
C Channel select button
This indicates the channel number, the icon selected
for that channel, and the channel name. When you
press this button, that channel will be selected for
operations, and the corresponding [SEL] key will
light.
Using the Centralogic section
1
2
3
• If you want to monitor the signal being sent to a specific MIX
bus, use the navigation keys to access the corresponding MIX
channel in the Centralogic section, and press the [CUE] key
for that MIX channel.
HINT
1 7 8
2
3
4
5
6