Filter
Top Products
Sending the signal from an input channel to the MATRIX buses
M7CL Owner’s Manual
Input channel operations
5
73
D TO MATRIX SEND ON/OFF button
This is an on/off switch for the signal sent from the
input channel to MATRIX bus.
An indication of “PRE” in black characters on a white
background is shown above these buttons only if PRE
(pre-fader) is selected as the position from which the
signal is sent from the input channel. This indication is
not shown for POST (post-fader). (For details on how
to switch between PRE and POST → p. 87).
4
In the TO MIX/TO MATRIX field in the
screen, make sure that the TO MATRIX but-
ton is turned on.
When the TO MATRIX button is on, the TO MIX/TO
MATRIX field shows the knobs and buttons for
MATRIX buses 1–8. If this button is off, press the but-
ton to turn it on.
If necessary, you can specify two adjacent odd-num-
bered/even-numbered MATRIX buses as a stereo bus
and link the main parameters (→ p. 234).
If the send-destination MATRIX bus is assigned as
stereo, the left knob of the two adjacent TO MATRIX
SEND LEVEL knobs will operate as the TO MATRIX
PAN knob (for a ST IN channel, it will operate as the
TO MATRIX BALANCE knob).
For an INPUT channel, the right knob will adjust the
common send level to the two MATRIX buses, and the
left knob will adjust the panning between the two
MATRIX buses. Turning the left TO MATRIX SEND
LEVEL knob toward the left will increase the amount
of signal sent to the odd-numbered MATRIX bus, and
turning it toward the right will increase the amount
sent to the even-numbered MATRIX bus.
For a ST IN channel, the right knob adjusts the com-
mon send level for the two MATRIX buses, and the
left knob adjusts the volume balance of the left and
right signals sent to the two MATRIX buses. Turning
the left TO MATRIX SEND LEVEL knob toward the
left will increase the amount of signal sent from the L-
channel to the odd-numbered MATRIX bus, and turn-
ing it toward the right will increase the amount sent
from the R-channel to the even-numbered MATRIX
bus.
5
Make sure that the TO MATRIX SEND ON/
OFF button is turned on for the send-desti-
nation MATRIX bus.
If this button is off, press the button in the screen to
turn it on.
6
In the SELECTED CHANNEL section, use
the MATRIX SEND LEVEL knobs to adjust
the send levels to the MATRIX buses.
7
You can use the top panel [SEL] keys to
switch input channels and control the send
level to the MATRIX buses in the same way.
• If necessary, the TO MATRIX PAN/TO MATRIX BALANCE
knob setting can be linked with operations of the TO ST PAN/
TO ST BALANCE knob shown in the STEREO/MONO field of
the OVERVIEW screen (
→
p. 234).
HINT
• If you want to monitor the signal being sent to a specific
MATRIX bus, use the navigation keys to access the corre-
sponding MATRIX channel, and press the appropriate [CUE]
key in the Centralogic section.
HINT