Filter
Top Products
M7CL Owner’s Manual
Operations in the Centralogic section
102
● Adjusting the send levels from a channel to
all MIX buses / MATRIX buses
In the OVERVIEW screen, you can use the TO MIX / TO
MATRIX field to send signals from a channel to the MIX
buses and MATRIX buses. This field includes the follow-
ing items.
1 TO MIX/TO MATRIX SEND LEVEL knob
Adjusts the send level of the signal sent from the input
channel to each MIX bus / MATRIX bus. To adjust the
value, press the knob for the desired bus to select it,
and operate multifunction encoders 1–8.
If the send-source is an input channel, you’ll need to
first select the send-destination buses (MIX buses or
MATRIX buses). Use the SELECTED CHANNEL
VIEW screen TO MIX/TO MATRIX button (→ p. 92)
to make this selection. The screen will change as fol-
lows according to the buses you select.
Press the selected knob once again, and the MIX
SEND / MATRIX SEND popup window (8 ch) will
appear, depending on the send-destination buses you
selected. This popup window contains on/off switches
for the signals sent from the channel to the corre-
sponding buses, and lets you select the send point
(PRE or POST). (For details on the popup window →
p. 234).
If the send-destination MIX bus or MATRIX bus is set
to stereo, the left of the two adjacent knobs will oper-
ate as the TO MIX PAN or TO MATRIX PAN knob
(or as the BALANCE knob if the send-source channel
is stereo).
These knobs will adjust the panning between two
buses that are set to stereo. (For a stereo channel, they
will adjust the volume balance of the left and right
channels sent to the two buses.)
B TO MIX SEND ON/OFF button
These are on/off switches for the signal sent from the
input channel to the MIX buses. These buttons are
shown only when the send-source is an input channel
and the send-destination is a FIXED type MIX bus.
To switch the on/off status of the signal sent from the
channel to VARI type MIX buses or to MATRIX buses,
press the selected knob once again to open the MIX
SEND / MATRIX SEND popup window (8 ch). (Alterna-
tively, you can use the SELECTED CHANNEL VIEW
screen.)
● Adjusting the send levels from all MIX chan-
nels to a MATRIX bus
In the OVERVIEW screen, you can simultaneously adjust
the send level of the signals sent from all MIX channels to
each MATRIX bus.
To do this, use the [MATRIX] key of the NAVIGATION
KEYS section to assign MATRIX channels 1–8 to the
Centralogic section. At this time, the OVERVIEW screen
will show the FROM MIX field. This field includes the
following items.
1 FROM MIX SEND LEVEL knob
For each MATRIX bus, this shows the send level of
the signals sent from MIX channels 1–16. To adjust
the value, press the knob to select it, and operate mul-
tifunction encoders 1–8.
If you press the selected knob once again, the
MATRIX SEND popup window (8 ch) will appear. In
this popup window you can switch the on/off status of
the signal sent from a specific MIX channel to
MATRIX buses 1–8, and select the send position
(PRE/POST). (Use the / buttons in the window
to select MIX channels. For details on the popup win-
dow → p. 70).
1
If MIX buses are
selected as the send-
destination
If MATRIX buses are
selected as the send-
destination
TO MIIX PAN/
TO MATRIX PAN knob
2
1