Filter
Top Products
M7CL Owner’s Manual
Using an external head amp
194
4
If you are using the M7CL-32/48, in order to
specify the input ports for an external HA,
press the EXTERNAL HA PORT SELECT
popup button for that rack.
The EXTERNAL HA PORT SELECT popup window
will appear. The popup window includes the following
items.
1 PORT SELECT buttons
These buttons specify the input ports to which the
external HA is connected.
B NO ASSIGN button
This button defeats the port selection.
5
If you are using the M7CL-32/48, use the
PORT SELECT buttons to specify the input
ports to which the audio output of the exter-
nal HA is connected.
When you’ve finished making settings, press the
CLOSE button to close the popup window.
6
To remotely control an external HA, press
the rack in which the external HA you want
to control is mounted.
The EXTERNAL HA popup window will appear.
Here you can remotely control the external HA by
using the knobs and buttons in the M7CL’s display or
the encoders of the top panel.
1 +48V MASTER
If an external HA is connected to the REMOTE con-
nector, the on/off status of the master phantom power
is shown here. (Switching this on/off is performed on
the external HA itself.)
B +48V buttons
These switch phantom power on/off for each channel.
C GAIN knobs
These indicate the gain of the external HA. To adjust
the value, press the knob to select it, and use multi-
function encoders 1–8. The level meter located at the
immediate right of the knob indicates the input level
for the corresponding port.
D FREQUENCY knobs / HPF buttons
These controls switch the external HA’s built-in high-
pass filter on/off, and adjust its cutoff frequency. If you
press the FREQUENCY knob to select it, you’ll be
able to adjust it using the corresponding multifunction
encoder.
E Rack select tabs
These tabs switch the rack that is displayed in the
EXTERNAL HA popup window.
1
2
• The input ports are fixed on the M7CL-48ES.
NOTE
• If an external HA is connected to one of the M7CL-32/48’s
slots, you must specify the appropriate input port manually. If
this is set incorrectly, the external HA will not be detected cor-
rectly when you patch input ports to input channels.
NOTE
2
3
1
4
5
• If you newly connect an AD8HR, the setting for this AD8HR
will be used.
These knobs and buttons are shown in the EXTERNAL HA
popup window even if an AD8HR is not connected, allowing
you to create and store a scene even while the AD8HR is not
connected.
• If SB168-ES units are connected to the M7CL-32/48, the dis-
play will indicate as if two AD8HRs (e.g., AD8HR #1 and
AD8HR #2) per SB168-ES were connected to the M7CL-32/
48, and you can control the SB168-ES units in the same way
as the AD8HRs.
However, the following parameters are not supported. Even if
these parameters are displayed, you will be unable to set val-
ues.
Device Mode/Name, Word Clock Source, Gain Trim,
Panel Lock, LED Brightness
• Error messages related to the SB168-ES will not be dis-
played. In addition, you will be unable to set the EtherSound
parameters. Use the AVS-ESMonitor software application for
these functions.
HINT