Filter
Top Products
PSR-3000/1500 Owner’s Manual
16
Introduction
Playing the Keyboard
Power Supply
1 Make sure that the PSR-3000/1500’s STANDBY/ON switch is set to
STANDBY (off).
2 Connect one end of the AC cable to the PA-300.
3 Connect the PA-300’s DC plug to the PSR-3000/1500’s DC IN terminal
on the instrument’s rear panel.
4 Connect the other end (normal AC plug) to the nearest electrical out-
let.
WARNING
Do not attempt to use an AC
adaptor other than the
Yamaha PA-300 or an equiva-
lent recommended by
Yamaha. The use of an incom-
patible adaptor may cause
irreparable damage to the
PSR-3000/1500, and may
even pose a serious shock
hazard! ALWAYS UNPLUG
THE AC ADAPTOR FROM THE
AC POWER OUTLET WHEN
THE PSR-3000/1500 IS NOT
IN USE.
CAUTION
Never interrupt the power
supply (e.g. unplug the AC
adaptor) during any PSR-
3000/1500 record operation!
Doing so can result in a loss of
data.
CAUTION
Even when the switch is in the
“STANDBY” position, electric-
ity is still flowing to the
instrument at a minimum
level. When not using the
PSR-3000/1500 for an
extended period of time, be
sure to unplug the AC power
adaptor from the wall AC out-
let.
DC IN
To electrical outlet