Filter
Top Products
112
Performance Mode
■ Gain
Set the Gain. This attenuates or boosts frequencies
around the Frequency setting.
❏ Settings: -12dB ~ 0dB ~ +12dB
■ Freq (Frequency)
Set the center frequency. Frequencies around this
point are attenuated/boosted by the Gain setting.
❏ Settings: 32Hz ~ 2.0kHz
■ Q (Frequency Characteristic)
This varies the signal level at the Frequency setting
to create various frequency curve characteristics.
❏ Settings: 0.1 ~ 12.0
EQ LowMid (Low-Middle Range)
EQ Mid (Middle Range)
EQ HighMid (High-Middle Range)
These Equalizers cover low-to-middle, middle and high-
to-middle frequency ranges. They can be used to adjust
the signal level around the specified frequency.
■ Gain
Set the Gain. This attenuates or boosts frequencies
around the Frequency setting.
❏ Settings: -12dB ~ 0dB ~ +12dB
■ Freq (Frequency)
Set the center frequency. Frequencies around this
point are attenuated/boosted by the Gain setting.
❏ Settings: 100Hz ~ 10.0kHz
MEQíLowMid) Gain Freq Q
Common +12dB 100Hz 12.0
MEQíMid) Gain Freq Q
Common +12dB 100Hz 12.0
MEQíHighMid) Gain Freq Q
Common +12dB 100Hz 12.0
Low Mid
Mid
High Mid
—
+
0
0.1
12.0
Frequency
Freq
■ Q (Frequency Characteristic)
This varies the signal level at the Frequency setting
to create various frequency curve characteristics.
❏ Settings: 0.1 ~ 12.0
EQ High
This Equalizer covers high frequencies. You can adjust
the signal level at the specified frequency. You can also
select different Equalizer types (Shapes).
■ Shape
Select either a Shelving or Peaking equalizer. The
Peaking type attenuates/boosts the signal at the
specified Frequency setting, whereas the Shelving
type attenuates/boosts the signal at frequencies
above or below the specified Frequency setting.
❏ Settings: shelv (Shelving), peak (Peaking)
■ Gain
Set the Gain. This attenuates or boosts frequencies
around the Frequency setting.
❏ Settings: -12dB ~ 0dB ~ +12dB
■ Freq (Frequency)
Set the center frequency. Frequencies around this
point are attenuated/boosted by the Gain setting.
❏ Settings: 500Hz ~ 16.0kHz
■ Q (Frequency Characteristic)
This varies the signal level at the Frequency setting
to create various frequency curve characteristics.
❏ Settings: 0.1 ~ 12.0
Common Effect
You can set two types of Insertion Effects, plus two
System Effects (Reverb and Chorus). The following
three screens are available.
EFF Part
EFF Rev (Reverb)
EFF Cho (Chorus)
EFF Part
EFFíPart) ---- InsEF ----
Common part16 partPL
MEQíHigh) Shape Gain Freq Q
Common peak +12dB 0.5kHz 12.0