Filter
Top Products
9
■ Attaching the Frame Unit
The Silent Bass is shipped from the factory with the Frame Unit removed from the main
body.
Please properly attach the Frame Unit using the following procedure.
•Make sure that Fixing Knobs 1-3 are tightened firmly. If they are left loose, it may result in rattle or noise
during performance.
•When transporting the instrument, always hold it by its neck or main body. Holding by the frame unit only
may result in damage to the frame unit.
1
Open the frame unit’s armrest until it comes in contact
with the stopper.
2
Fully loosen the [Fixing Knob 2] located on the bottom
end of the main body.
3
Align the cut end of the Frame Unit with the post above
the [Fixing Knob 2] and fully insert. Then, align the notch
at the top of the Frame Unit so it rests on the top of the
bass’ main body and slowly insert.
4
Turn the [Fixing Knob 1] located on the upper portion
of the frame unit clockwise until it is tight, to attach the
frame unit to the body.
5
Turn the [Fixing Knob 2] on the bottom end of the main
body clockwise (looking from the bottom) until it is tight,
to attach the frame unit to the body.
6
Align the [Fixing Knob 3], located on the center of the
frame unit, with the Fixing Knob Plate located on the
center of the main body, then turn clockwise to tighten.
When you move the frame unit’s
center section, be careful not to
pinch your fingers, hand, etc.
This completes attachment of the frame unit.
To remove the frame, simply reverse the order of the previous procedure.
1
2
3
4
5
Fixing Nut 2
Fixing Knob 1
3
Tighten
6
Fixing Knob 3
Tighten
Tighten
Loosen
08.7.11, 3:51 PMPage 9