Filter
Top Products
Appendix
MG32/14FX, MG24/14FX
24
■ Digital effect type list
• Common to EFFECT 1 and 2
• EFFECT 1
• EFFECT 2
* The LED can not blink any faster than an interval of 256 ms (234.3 bpm).
No. Type Description
Controllable parameter
Parameter Variable range
1 REVERB HALL Reverberation simulating a spacious expanse such as a concert hall. Reverb time 0.3–10.0 s
2 REVERB ROOM Reverberation simulating the acoustics of a small room. Reverb time 0.3–3.2 s
3 REVERB PLATE Simulation of a plate reverb device. Produces a hard-sounding rever-
beration.
Reverb time 0.3–10.0 s
4 REVERB VOCAL 1 Ideal reverb for vocals. Reverb time 0.3–10.0 s
5 REVERB VOCAL 2
6 VOCAL ECHO 1 Ideal echo for vocals. Delay time 0–800 ms
7 VOCAL ECHO 2
8 DELAY 1 Delay effect that delays the signal. Delay time 0–800 ms
9 DELAY 2
0 MOD. DELAY Monaural delay with modulation. Delay time 0–800 ms
A REVERB GATE An effect that simulates reversed early reflections. Room size 0.1–10.0
B PITCH CHANGE An effect that changes the pitch of the input signal. Pitch –12–+12
C CHORUS Modulates the delay time of the signal to add depth to the sound. Depth 0–100%
D PHASER An effect that changes the phase of the sound to create modulation. Modulation frequency 0.05–4.00 Hz
E RADIO VOICE An effect that produces a lo-fi sound like that of an AM radio. Drive 0–100
F TREMOLO An effect that adds modulation to the sound. Modulation frequency 0.05–10.00 Hz
0 EARLY REF. An effect produced by modifying the early reflections. It lets you add
depth to the sound, or create echo-like effects.
Room size 0.1–10.0
A GATE REVERB An effect produced by cutting the reverberation. Room size 0.1–5.0
B VOCAL DOUBLER Produces an effect as though two people were singing. Pitch fine 0–50
C SYMPHONIC Gives a richly layered depth to the sound. Depth 0–100%
D FLANGE Adds a sense of pitch to the tone. Effective on sounds that contain
numerous overtones.
Modulation frequency 0.05–4.00 Hz
E DISTORTION The well-known effect used to distort the sound. Drive 0–100
F TAP DELAY This effect sets the delay time to the interval at which you actually
press the switch. The amount of feedback can be adjusted by the
PARAMETER control. The LED will blink in synchronization with the
delay time.
Feedback gain 0–99%
Delay time 100 ms (600 bpm)
–2690 ms
(22.3 bpm)*