Filter
Top Products
ZOOM G2
8
Selecting a Patch
A 1
HINT
Turn power on
Set the G2 to play mode
Use a monaural shielded cable to connect
the guitar to the [INPUT] jack of the G2.
When using the G2 with the AC adapter,
plug the adapter into the outlet and plug
the cable from the adapter into the [DC
IN] jack on the G2.
Turn the guitar amplifier on and adjust
the volume to a suitable position.
If the Module selector is set to a position
other than "PLAY", set it to "PLAY".
The bank and patch
that were selected
when the power was
last turned off will
appear on the display.
Select a patch
To switch the patch, press one of the [W]/[Q] foot switches.
Pressing the [W] foot switch calls up the next lower patch, and pressing the [Q] foot
switch calls up the next higher patch.
Repeatedly pressing one foot switch cycles through patches in the order A0 – A9 ... d0 – d9
→ 00 – 09 ... 30 – 39 → A0, or the reverse order.
Immediately after turning the G2 on, the
unit will be in play mode, even if the
Module selector is set to a position other
than "PLAY".
Set the [POWER] switch on the rear
panel of the G2 to ON.
Bank name Patch number
To try out the various effects of the G2, we recommend that you simply play your instrument while
switching patches.
Selecting a Patch
ZOOM G2
9
Adjust tone and volume
To adjust the effect sound and volume
levels in play mode, the Parameter
knobs 1 – 3 can be used. Each knob
controls a specific parameter.
When you turn a Parameter knob, the
corresponding LED lights up and the display
briefly shows the current value of the respective
parameter.
NOTE
• If the DRIVE module is set to OFF for
the currently selected module
(display shows "oF"), Parameter
knobs 1 and 2 have no effect.
• Changes made here are temporary
and will be lost when you select
another patch. To retain the changes,
store the patch in the user area.
• The master level in common to all
patches is set in edit mode (→ p. 30).
Parameter knob 2
Parameter knob 1 Parameter knob 3
Adjusts the GAIN
parameter of the
DRIVE module (mainly
distortion depth).
Adjusts the PATCH
LEVEL parameter
(output level of the
entire patch).
Adjusts the TONE parameter of the DRIVE
module (mainly distortion sound character).
Directly selecting a bank
To select the banks A – d, 0 – 3 directly, use
the BANK [-]/[+] keys.
Pressing the BANK [-] key calls up the next lower bank, and
pressing the BANK [+] key calls up the next higher bank.