Installing and Operating the Module 3 - 3
4. Keep the carton and anti-static bag in which your module was
shipped for repackaging the module for storage or shipment.
5. Record the serial number of your 10BASE-FL Module. A log and other
information specific to your modules is included in the ONline System
Concentrator Installation and Operation Guide, Appendix B, Slot
Usage Chart.
Quick Installation
Table 3-1 outlines the steps for installing your module.
Table 3-1. Quick Installation Procedures
Step Procedure Section Title
1. Verify that your network complies with
basic rules for network design.
Chapter 2, Designing
and Expanding the
Network
2. Unpack the module. Unpacking
Procedures
3. If you do not have a management
module installed in the concentrator,
configure the dip switch settings to your
specifications.
Setting the Dip
Switches
4. Insert the module into a blank slot in the
concentrator and tighten the faceplate
screws.
Installing the Module
5. Establish connections from the
10BASE-FL Module to another 10BASE-FL
Module or 10BASE-FL Transceiver using
the appropriate connectors and cabling.
Installing the Module
