Remote Software Download 113
Procedure
Recommendation
: Prior to performing remote software download,
configure your switch. Perform the procedure in Chapter 2
, Managing
the VCN Access Concentrator, section Configuring the Ethernet Switch
for the VCN Access Concentrator.
To use the VCN AP to download software perform the following steps:
Downloading Software to the LCs in the VCN AC
1
Remove the cover of the LMA section of the VCN AP to reveal the LMA
port, as shown in Figure 86
.
Figure 86 LMA Section of the VCN Access Point
2
Connect the management computer to the VCN AP LMA port.
3
Using RJ-45 connectors, connect the Ethernet port of the VCN AP to an
Ethernet switch 10BaseT port, as shown in Figure 87
. Refer to Figure 88
for the network configuration.
Recommendation: Attach the downloading VCN AP to port
■
26 in the VCN Services Switch 10.
■
26 in the SuperStack II Switch 1100.
■
24 in the VCN Services Switch 100.
■
24 in the SuperStack II Switch 3300.
Fax-ModemETHERNET
Line
Power
crew hole
Local
Management Port
