Voice Over IP 17
T0008-48/B Revision 5.2
Configuring VoIP
Parameters These SoTCP map table parameters should be configured:
Note
A node boot is required for changes to these parameters to take affect.
Entry Number
Range 1 to 32 for PathBuilder S21x switch
1 to 64 for PathBuilder S24x, 26x, and 27x switch
Default 1
Description Specifies the number used to reference this table record.
Destination Address
Range 0 to 15 digits.
Default blank
Description Specifies the network address for calls for which TCP sessions
must be established. Use space to blank the field.
Destination IP Address
Range X.X.X.X. (Where X is between 0 and 255.)
Default 0.0.0.0
Description Specifies the unicast IP address of the node to which calls are
routed. Calls with a network address corresponding to this entry
will establish a TCP session with this destination.
Note
You may configure up to four destination IP addresses for each
destination X.25 address. This allows a user to specify alternate
destination IP addresses to connect to the same destination X.25
address.
