GETTING STARTED: Basic hookups and settings
2 TURNTABLES REAR PANEL
REAR PANEL USING 2 TURNTABLES:
AC power adapter connects to “20V~1A”
Left turntable goes to “PHONO1/LINE1” using dual RCA cords, and the ground wire goes to the
GND screw above AUX2
“LINE1/PHONO1” switch set to “PHONO1”
Right turntable goes to “PHONO2/LINE3” using dual RCA cords, and the ground wire goes to the
GND screw above AUX1
“LINE3/PHONO2” switch set to “PHONO2”
For powered speaker or amplifier connection, either use XLR cables on the “MASTER
BALANCED OUTPUT” or RCA cables on the “MASTER” output.
***Only turn the power switch on once you have finished the hookup, understand the setup,
and set all faders to minimum volume.
2 SINGLE / 1 DUAL CD PLAYER REAR PANEL
REAR PANEL USING 2 SINGLE CD PLAYERS / 1 DUAL CD PLAYER:
AC power adapter connects to “20V~1A”
Left CD source goes to “LINE 2” using a dual RCA cord.
