CHAPTER 4: BASIC OPERATIONS
38
Next to each item to be tested, you will see a pass (green circle) or fail (red x) symbol
display to the left of each item as that test finishes. The following table details each of the
tests.
To run diagnostic tests:
1. If the OSD interface is not open, press Print Screen. The Main dialog box will
appear.
2. Click Commands - Run Diagnostics. A warning message displays indicating that all
users will be disconnected.
Diagnostic Test Details
Test Description
Memory Tests
Reports on the condition of the main
board RAM
Firmware CRCs
Reports on the condition of the main
board RAM
Comm Interfaces
Validates the current firmware images
stored in the system’s Flash
Switch Controller test
Verifies the switch matrix controller is
accessible and functional
Local Video
Indicates the condition of the local
video monitor
On-line Targets
Indicates the total number of currently
connected and powered targets
Offline Targets
Indicates the number of targets that
have been connected successfully in
the past and are powered down
Suspect Targets
Indicates the number of targets that
have been detected, but are either
unavailable for connection or have
dropped packets during the ping tests
