724-746-5500 | blackbox.com
Page 178
Chapter 7: Command-Line Management
3. Command Syntax:
(no) lldp rcv-pkt
4. Example:
The following example receives Link Layer Discovery Protocol (LLDP) packets on the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#lldp rcv-pkt
switch_a(config-if)#
Notify:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to enable Link Layer Discovery Protocol (LLDP) notification on the interface.
Use the no parameter with this command to disable Link Layer Discovery Protocol (LLDP) notification on the interface.
3. Command Syntax:
(no) lldp notification
4. Example:
The following example enables Link Layer Discovery Protocol (LLDP) notification on the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#lldp notification
switch_a(config-if)#
TLVs:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
