Master Hub Configuration & Console Management 83
Group Last Changed: The value of system uptime since any of
the following conditions occurred:
• hub cold or warm-started
• this instance of group was created (such as, when a device
or module was added to the system)
• a change in the value of hub operational status
• ports were added or removed as members of the group
(such as, group admin. enabled or disabled)
• any of the counters associated with this hub that have
been reset.
Group Partitioned Ports: The total number of partitioned ports
in the group.
Group Operational Status
• Operational: The hub is connected to the stack.
• Not Present: The hub is not present.
Group Control
Lists the configurable functions and provides option fields. Use Ctrl + S
to toggle between options.
Group Admin State: Allows you to isolate one or both
segments from the other hubs in a 10/100 Managed Hub. When
a segment is disabled, the segment cannot repeat to the other
hubs in the stack. The default value is Enabled 10Mbps and
100Mbps.
• Enable 10-100 (Default): Both 10Mbps and 100Mbps
segments of a given hub are connected to the backplane of
the stack. This is the default.
• Disable 10-100: Both 10Mbps and 100Mbps segments of
the hub are isolated from the stack.
• Enable 10: Only the 10Mbps segment of a given group is
connected to the backplane of the stack. The 100 Mbps
segment of a given group is isolated from the stack.
• Enable 100: Only the 100Mbps segment of a given group is
connected to the backplane of the stack. The 10Mbps
segment of a given group is isolated from the stack.
