A SERVICE OF

logo

Open as PDF
next previous
CHAPTER 3: Installation
21
INIT–NOR
jumper, JP2 This jumper is used to select the default set of configuration parameters stored
in the Fradswitch. The jumper has two positions:
NOR Normal operation. The Fradswitch uses the parameters
selected by the user during the last configuration session.
INIT Initialization. When it is turned on, the Fradswitch loads the default
configuration (determined by the factory and common to all the
Fradswitch series units). To select the default configurations, use the
procedure described in Section
3.10 of the Packet Switching Guide.
The factory setting is NOR.
Figure 3-2. Fradswitch-8A, identification of internal jumpers.
JP2
INIT
NOR
JP1
GND
CON
DIS