VideoJet 8008 / VideoJet 8004 | Installation and Operating Manual
EN | 25
Bosch Security Systems | 2006-07 | V1.5 Installation
Setup using a terminal program
Data terminal
You can connect a data terminal to the unit for setup and local control. The data
terminal consists of a computer with a terminal program. Use the configuration
cable supplied to establish the connection.
HyperTerminal, a communications accessory included with Microsoft Windows,
can be used as the terminal program.
Note
Information on installing and using HyperTerminal can be found in the
manuals or in the online help for MS Windows.
– Disconnect the unit from the data network before working with the terminal
program.
– Connect the unit's RS232/485 RJ45 socket to a free serial interface on the
computer.
Configuring the terminal
Before the terminal program can communicate with the unit, the transmission
parameters must be matched. Make the following settings for the terminal program:
❚ 19,200 bit/s
❚ 8 data bits
❚ No parity check
❚ 1 stop bit
❚ No protocol
